Rubber Cleated Corrugated Sidewall Belt Conveyor Large Slop
This Sidewall belt conveyor with corrugated shield, in particular
applied in conveying material in big inclination, for it with
corrugated shield and horizontal clapboard belt. And it can widely
used in coal, metallurgy, chemical industry, light industry,
petroleum, port, mechanical etc to convey all kinds of bulk
materials and the piece.
Density of handled bulk materials 500~2500kg/m3, max inclination is
90°, max lump size is 550mm, lump of handled should depends on belt
width, belt speed, clapboard height and inclination.
Ambient temperature generally -25~+40℃, material temperature to be
handled should be under 50℃. It should take other measures for
special requirement such as heat resistant, proof cold, resistant
retard, resistant acid and alkali, resistant abrasion, proof
explosion, proof water etc.
Advantages And Features
Technical parameters for reference
Remarks: the below capacity is based on coal and speed 1m/s to
caculated for reference.
|Pitch of cleats||126mm||252mm||126mm||252mm||378mm||252mm||378mm|
|Slop||30 degree||39 t/h||21 t/h||-||52 t/h||34 t/h||65 t/h||45 t/h|
|40 degree||31 t/h||16 t/h||-||40 t/h||26 t/h||52 t/h||34 t/h|
|50 degree||25 t/h||13 t/h||60 t/h||32 t/h||-||42 t/h||27 t/h|
|60 degree||20 t/h||11 t/h||50 t/h||26 t/h||-||34 t/h||23 t/h|
|70 degree||17 t/h||-||41 t/h||21 t/h||-||28 t/h||18 t/h|
|90 degree||10 t/h||-||25 t/h||-||-||17 t/h||-|
- Material to be processed: _____
- Max. granule size of the feeding material: _____mm
- Handling capacity (Ps. It means the total material capacity feeding
from the inlet): _____t/h
- Percentage of Max. granule in material:_________%
- Upstream equipment (Ps. It means what kind of Equipment is used to
feed the material):____
- Bulk Density: _____t/m3
- Material temperature: _____℃;
- Downstream equipment (Ps. It means what kind of equipment is used
to discharge the material): _____
- Water content:____%
- Material is corrosive or not: ____ (Ps. Yes or No)
- Working power supply: _____V ______HZ
- Material is sticky or not: ____ (Ps. Yes or No)
- Working environment is indoor or outdoor: _______
- Working environment temperature: ______ ℃
- Please refer to the following picture and provide the relevant
parameters:L1____m, L2___m, H___m, α____°
Operation regulation and maintenance
- Belt conveyor should be operated in according to design
Belt conveyors are not allowed to overload run.
All safe alarming should be in good condition.
Check wear condition of the belt, the damaged should be repaired.
Operators should circuit to inspect to close observe belt conveyor
running. Especially,temperature rise and noise of main motor and
the brake working whether they are normal; contact state of the
brake and oil level, noise of gear unit and run off of belt should
be noticed;temperature rise and noise of all bearings and state of
all transition loads point should be noticed;
notice to see whether the hopper are blocked, working state of
pulley, idler, belt cleaner, take-ups and control equipment.